datsun-roadsters
[Top] [All Lists]

RE: frozen nut on hub assembly

To: datsun-roadsters@Autox.Team.Net
Subject: RE: frozen nut on hub assembly
From: Sumton Network Services <sumton@sbcglobal.net>
Date: Sat, 11 Dec 2004 22:37:49 -0800 (PST)
pb blaster has gotten many things unstuck for me.  but - patience is the word.  
you may have to also use a smoky wrench - i.e., a torch or flame of some kind.  
heat, pb, heat, pb.  come back tomorrow, and do it again.  and the next day.  
and the next day.  

Gordon Glasgow <gsglasgow@comcast.net> wrote:Jim, the advice you've already 
received from others on the list is correct.
Marinate in PB Blaster, try a 6-point socket, etc. If you go the socket
route, you might also try using an impact wrench (if you have air supply),
or you might try one of the pseudo-impact-wrench units that you hit with a
hammer (not sure what they're called). If you go after it with a torch, be
sure you clean all the grease out of the hub first. A hub and rotor assembly
makes a lousy hibachi.

Or you could take the easy way out and take it to a machine shop and have
them do it.

> -----Original Message-----
> From: owner-datsun-roadsters@Autox.Team.Net
> [mailto:owner-datsun-roadsters@Autox.Team.Net]On Behalf Of Jim Sylvester
> Sent: Saturday, December 11, 2004 8:25 AM
> To: datsun-roadsters@Autox.Team.Net
> Subject: frozen nut on hub assembly
>
>
> I'm at my wits end with a simple task so I thought I would see if anyone
> else has approached this issue in a different way.
>
> The four bolts that hold the hub assembly to the disk brake rotor
> are simply
> too frozen to move. I've soaked everything with 3-in-1 oil and
> pounded and
> pounded to no avail other than to begin to round the end of the bolts. To
> make matters worth, I'm having to work with the open end of the wrench
> because - unlike the passenger side - on the drivers side hub assembly I
> can't get the box end of the wrench over the end of the bolt.
>
> Any ideas? I'm afraid if I keep pounding with the open end of the wrench
> I'll just finish rounding the ends of the bolts and REALLY be sunk.






<Prev in Thread] Current Thread [Next in Thread>