>Ken Asked - Anyone have any tips or tricks for removing the crank pulley
bolt on a U20?
This is how I did it:
Trans in 5th
E brake on
Wheel chocks on rear wheels
No problem!
To get the pulley of after the nut was removed, I used the long 6mm bolts
from the fan and threaded them through the holes in the pulley. I used a
couple pieces of steel to chushion the ends of the bolts to keep them from
digging into the timing cover. tighten the bolts to drive the pulley off.
Victor
70 SRL 31113136
71 PL510 <Comming Soon!
72 HLS30 94071
65 L-320 Pickup
Los Angeles
SoCalROC http://www.socalroc.com/
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|