My thermostat housing came off without any problem at all. I was all pumped
up for a fight, but after I got the bolts undone it just lifted right off.
BTW, is there any negative effects of using stainless steel hardware in
aluminum?
-----Original Message-----
From: owner-datsun-roadsters@autox.team.net
[mailto:owner-datsun-roadsters@autox.team.net]On Behalf Of datsunmike
Sent: Monday, July 02, 2001 3:21 PM
To: L Jordan; Datsun Roadster List
Subject: Re: thermostat housing removal tips x-mac-creator="4D4F5353"
I use stainless bolts rather than studs and it works fine. Just remember to
put teflon tape on the threads and some Form-a-Gasket or even a dab of
silicone to make sure it doesn't leak through the threads. I also smear
antiseize on the length of the bolts.
Mike
----- Original Message -----
From: "L Jordan" <ay107@lafn.org>
To: "Datsun Roadster List" <datsun-roadsters@autox.team.net>
Sent: Monday, July 02, 2001 11:44 AM
Subject: thermostat housing removal tips x-mac-creator="4D4F5353"
> List,
> Any tips for removing the thermostat housing? We need to remove it
> replace the thermostat and reinstall hopefully in a way that will allow
> easier removal next time.
> thanks,
> Linda
|