buick-rover-v8
[Top] [All Lists]

Re: removing a buick 215

To: "John Linville" <bellytk@nh.ultranet.com>
Subject: Re: removing a buick 215
From: David Kernberger <dkern@napanet.net>
Date: Thu, 5 Apr 2001 18:45:42 -0700
Later:  Sent again---I forgot to remove the garbage from the bottom of
John's original message.

-------------

4/5/01

John,

        If you drop the suspension to pull the engine, then you will have
to put it back so the guy will still have a whole car.  Too much work, I
suspect.  Though I have not pulled one in many years, I remember just
following the usual procedure of pulling the transmission, then hoisting
the engine out the top.  There may be a bit of a tight squeeze past the
heater ductwork, at least if it is a '61.

Cheers,  Dave Kernberger

----------------------------------------------------

>Hi, I am buying a Buick 215 to install it in my Morris Minor woodie.  Guy
>wants to keep the car but will sell the motor.  I have to travel to adjacent
>state to pull the motor.  I am told they drop out the bottom with the
>suspension?  I expect a number of guys on the list have pulled these so I
>would appreciate your advice.  Intend to take engine crane, jack stands,
>cribbing, electric impact wrench, oxy-acetylene torch and four friends.
>Thanks, John (NH)

///
///  buick-rover-v8@autox.team.net mailing list
///


<Prev in Thread] Current Thread [Next in Thread>