4.4 crank in '88 Rangie block.

[Jan Ben <ben@lucent.com>]

1. sorry  for CCing some of you explicitly.. haven't seen you guys on
the list yet.

2. Any 1st-hand confirmation that the 1-pc rear seal will seal the 4.4
crank correctly?  According to the specs it should be OK.

3. What's the detail on the flywheel end of the 4.4 as far as fitting a
'88 RR auto flexplate, anybody?
Just redrill the flexplate ?   Will I need to open it up for the bigger
pilot bushing(spigot) on the 4.4 crank, or is it big enuff already?
Jan