Hi Don,
I guess I offended you. Sorry.
I will point out that I've had pretty bad luck with certain manuals that
are out there when it comes to describing certain procedures. I don't need
to go into detail, but even some of the factory reprints are flat _wrong_!
At any rate, I give any Haynes manual a mediocre score when it comes to
accuracy and usefulness. Your initial question was about a Probe - go to
Ford and get a Probe manual. If that's too expensive, try to find a used
one.
I can't offer any more than that.
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-vms-help |
Voice:617-253-7438 FAX: 617-258-9535 |
------------------------------------------------------------------------------
|