- 1. [TR] TR4A Front Wheel Bearings (score: 1)
- Author: "Dave Connitt" <dconnitt@fuse.net>
- Date: Sun, 24 Aug 2008 20:29:15 -0400
- Hi List, OK, I have my TR4A chassis about half put together and I am about to install new wheel bearings in the front hubs. The wheel bearing kit has a inner and outer bearing, a small bag of grease,
- /html/triumphs/2008-08/msg00514.html (7,742 bytes)
- 2. Re: [TR] TR4A Front Wheel Bearings (score: 1)
- Author: "Randall" <tr3driver@ca.rr.com>
- Date: Sun, 24 Aug 2008 17:39:19 -0700
- Don't know that it's "best", but I've been just leaving them dry. Doesn't seem to hurt anything. I do recommend that when you're replacing the felt seal, but remember that the proper final position
- /html/triumphs/2008-08/msg00515.html (7,510 bytes)
- 3. Re: [TR] TR4A Front Wheel Bearings (score: 1)
- Author: "Andrew Uprichard" <auprichard@comcast.net>
- Date: Mon, 25 Aug 2008 07:41:29 -0400
- Randall: would you agree that the newer felt seals have a lot of (=too much) felt ? I actually peeled off a layer or two before installing. Andrew --Original Message-- From: triumphs-bounces+aupricha
- /html/triumphs/2008-08/msg00517.html (9,071 bytes)
- 4. Re: [TR] TR4A Front Wheel Bearings (score: 1)
- Author: "Randall" <tr3driver@ca.rr.com>
- Date: Mon, 25 Aug 2008 06:56:18 -0700
- I don't know if they are all that way, but it does seem to be common. But, as long as you set the bearing clearance without the felt in the way, it won't hurt anything. The procedure I suggested (ma
- /html/triumphs/2008-08/msg00518.html (7,806 bytes)
- 5. Re: [TR] TR4A Front Wheel Bearings (score: 1)
- Author: "Andrew Uprichard" <auprichard@comcast.net>
- Date: Mon, 25 Aug 2008 09:59:08 -0400
- Good suggestion - Thanks --Original Message-- From: triumphs-bounces+auprichard=comcast.net@autox.team.net [mailto:triumphs-bounces+auprichard=comcast.net@autox.team.net] On Behalf Of Randall Sent: M
- /html/triumphs/2008-08/msg00519.html (8,657 bytes)
This search system is powered by
Namazu