Search String: Display: Description: Sort:

Results:

References: [ +from:oldtoys@charter.net: 6 ]

Total 6 documents matching your query.

1. RE: Rookie Doing TR6 Rear Trailing Arm Bushings and Springs - (score: 1)
Author: "Creig Houghtaling" <oldtoys@charter.net>
Date: Sat, 26 Nov 2005 23:02:41 -0600
otherwise I'll start drilling through the rubber (any easier way?). I did get the new slip boot on as well. Marty, My tool for this job is a section of pipe that has an inside diameter slightly large
/html/triumphs/2005-11/msg00667.html (7,940 bytes)

2. [TR] TR6 A-Type OD in TR3? (score: 1)
Author: "Creig Houghtaling" <oldtoys@charter.net>
Date: Tue, 14 Mar 2006 19:11:31 -0600
Can a TR6 A-Type overdrive transmission be used in a TR3? I heard that the input shaft is different. If this would make it not work, is there any conversion that could be done using parts from a TR3
/html/triumphs/2006-03/msg00533.html (7,097 bytes)

3. RE: [TR] TR6 A-Type OD in TR3? (score: 1)
Author: "Creig Houghtaling" <oldtoys@charter.net>
Date: Tue, 14 Mar 2006 22:15:17 -0600
If you're going to all that fuss, have you considered the Toyota 5-speed tranny swap? -- Hoyt Yes. I also hear that John Esposito also has an English Ford Mercur 5-speed conversion kit. But there is
/html/triumphs/2006-03/msg00540.html (7,823 bytes)

4. RE: [TR] TR6 A-Type OD in TR3? (score: 1)
Author: "Creig Houghtaling" <oldtoys@charter.net>
Date: Tue, 14 Mar 2006 22:17:43 -0600
Sorry. I should have mentioned to avoid confusion, that I have a good a-type TR6 tranny and OD unit. I was just wondering if it would work in a TR3. Let me see if I understand. The shaft at the clutc
/html/triumphs/2006-03/msg00541.html (8,449 bytes)

5. RE: [TR] TR6 A-Type OD in TR3? (score: 1)
Author: "Creig Houghtaling" <oldtoys@charter.net>
Date: Tue, 14 Mar 2006 22:26:21 -0600
So if I use different fasteners between the transmission bell housing and the engine, the front connection should be OK. How much different is the mounting between the TR6 A-type overdrive and the TR
/html/triumphs/2006-03/msg00542.html (8,202 bytes)

6. RE: [TR] TR6 A-Type OD in TR3? (score: 1)
Author: "Creig Houghtaling" <oldtoys@charter.net>
Date: Tue, 14 Mar 2006 22:57:30 -0600
The exact dimensions of the difference isn't critical at this point. But the fact that it is different is important. But you say if different mounting holes are drilled into the frame it can work. Do
/html/triumphs/2006-03/msg00544.html (8,764 bytes)

Current List: 1 - 6
Page: [1]
This search system is powered by Namazu