So if I use different fasteners between the transmission bell housing and
the engine, the front connection should be OK. How much different is the
mounting between the TR6 A-type overdrive and the TR3 frame? Is there any
difference between the output flange of the TR6 a-type OD and the mating end
of the TR3 drive shaft?
Creig
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net]On Behalf Of Randall
Sent: Tuesday, March 14, 2006 9:38 PM
...
Randall
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.385 / Virus Database: 268.2.3/281 - Release Date: 3/14/2006
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|