Hi all, I am in the middle of changing both front and rear motor mounts (trans mount is OK). I could not locate my Helms for the torque specs, so I was wondering if anyone had access the specs for th
OK, I've got the torques specs--(THANKS Jim and Deb Leyden), but now Mr. Murphy (Murphy's Law) has paid a visit. On the front mount, most of the one bolt severed near the locknut side fell out appare
I'll be changing rotors, pads, and calipers, and putting in new fluid of course. My ABS does not work--light has been on for over a year now, so I cannot activate the ABS using the ol' loose gravel o
ABS light has been on for over a year. What do I use to test the sensors--a multimeter of some sort? What setting is appropriate, and what readings mean 'sensor good', what readings mean 'bad sensor?
I've got some weird noises in the front--different sounds for left and right side. I also need the front tension strut bushings (go through front of chassis) and a wheel bearing replaced. Anyone know
A while back I emailed the SHOcommunity about a noise coming from my front suspension suspension--a metallic clunk or crack that occurred during hard braking while turning right. Someone e-mailed a s
My ABS light glows steadily. I suspect a wheel speed sensor, though I've not run any codes. Does anyone know of a procedure that outlines how to electrically test each sensor (voltage or ohms or what
I will be replacing my subframe bushings on my b 92. I am not interested in any type of solid aluminum or Delrin bushings. I understand that the b 96+ MY bushings were made of a harder rubber and cou
I will be replacing my subframe bushings and possibly the subframe bushing bolts on my 1992 SHO. Ib ve seen the SHOtime FAQ writeup on bushing options, and the specs call for M12 x 1.5 x 100mm bolts
Any guidelines for routing the back e-brake cables? The Helms diagrams are not super clear, and I think the previous set were not optimally routed, causing premature 'stuck caliper.' I'd release the
Hello everyone, My mom bought a b 99 Lincoln Town Car Signature Edition (excellent condition, $6,500) with 122K on it while I was at the SHO convention. (That was her first mistake, doing this while
Hello all, My b Check Engineb light came on as I was returning from the convention. My first thought was b O2 sensorsb , but Ib d rather not replace them until I can verify if that is indeed the pro
Hello all, My CE light started glowing solid about on the return trip from the convention. I pulled the codes using a jumper wire and got the following (KOEO): 175 No HEGO switching detected / adapti