Teeth way to course. You might be able to do that if you used a very fine tooth carbide blade. The key to metal saws is to always have two teeth in contact with the metal at all times ( the work must
Grinding does not produce the proper finish for proper head gasket sealing. It is also much less accurate using the "head grinders" used in most shops that do not have milling equipment. Bill
If you are comfortable working in a fuse panel you can do the same thing with a simple two way blade switch of sufficient capacity to carry the load. Separate the lower section of the ground strip in
I bought a cast iron two stage, don't the exact specs here, for $800 form Home Depot. They delivered it with the portable fork lift and put it in my garage. So far it has been better than I expected.
Tim is correct. You can take it off without the tool, I have done it that way, and after you have done it once it is much easier the second time (don't ask how I know that). But I would use the tool.
Suggestion, why not use long 2x12's and get out of the car while you can open the door. Then push it into position. Bill /// unsubscribe/change address requests to majordomo@autox.team.net or try ///
2X4's should work and are a lot cheaper /// unsubscribe/change address requests to majordomo@autox.team.net or try /// http://www.team.net/mailman/listinfo /// Archives at http://www.team.net/archive
Please tell me you don't let your wife use it to clean house. Just kidding, but I don't like the idea of brake fluid inside my engine. Bill /// unsubscribe/change address requests to majordomo@autox.