Grinding does not produce the proper finish for proper head gasket
sealing. It is also much less accurate using the "head grinders" used in
most shops that do not have milling equipment.
Bill
At 07:14 PM 4/25/2004, MJSUKEY@cs.com wrote:
>I know when a shop mills a head or decks a block it is "cut, as in milling
>cutter". The question I have is... is there any reason that the head and or
>block could NOT be ground? Would this prevent the gasket from sealing
>properly?
>Any negatives?
>
>Thanks,
>Marty
|