Search String: Display: Description: Sort:

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*MGB\s+Front\s+Springs\s*$/: 27 ]

Total 27 documents matching your query.

21. RE: MGB Front Springs (score: 1)
Author: "Dean T. Lake" <dtlake@erols.com>
Date: Fri, 22 Aug 2003 07:08:54 -0400
I had this same problem on my GT. The springs simply do not have the effect that is listed in the Special Tuning manual or major US catalogues (yes, even when the springs are clearly labeled as comi
/html/mgs/2003-08/msg00564.html (9,046 bytes)

22. Re: MGB Front Springs (score: 1)
Author: "Paul M." <rowman22001@yahoo.com>
Date: Fri, 22 Aug 2003 12:20:42 -0700 (PDT)
This is true, and all things equal, most "performance" suspensions on the market are too low, resulting in screwy suspension geometry. My favorite part is that they are invariably advertised as "low
/html/mgs/2003-08/msg00569.html (9,222 bytes)

23. Re: MGB Front Springs (score: 1)
Author: "James Nazarian" <jhn3@uakron.edu>
Date: Fri, 22 Aug 2003 22:43:28 -0400
I can't speak for RBBs but I have found no noticeable increase in bump steer from going to the 550# 1" lowered CBB springs. James Nazarian 71 MGB Tourer 71 MGBGT V8 85 Dodge Ram -- Original Message -
/html/mgs/2003-08/msg00573.html (8,063 bytes)

24. Re: MGB Front Springs (score: 1)
Author: WSpohn4@aol.com
Date: Mon, 25 Aug 2003 18:05:38 EDT
I try not to THINK about them, much less speak about them.... but I have found no noticeable increase in bump steer That just means that you aren't cornering hard enough over surfaces with bumps to n
/html/mgs/2003-08/msg00595.html (7,714 bytes)

25. MGB Front Springs (score: 1)
Author: Rick Hopton <rhopton@vlint.com>
Date: Mon, 8 Feb 99 09:31:43 -0600
Is there a way to remove the front coil springs from an MGB (1980) without the special tool. I need to replace the lower bushes. Rick Hopton 1980 MGB 1968 MG Midget
/html/mgs/1999-02/msg00384.html (6,395 bytes)

26. Re: MGB Front Springs (score: 1)
Author: Tim Nagy <nagy@duq.edu>
Date: Mon, 08 Feb 1999 10:38:39 -0500
Look to http://www.mgb.bc.ca/service/front-suspension.html. Is a complete section on rebuild. I'd bet there is info on front spring removal. Was on the list a little while back. Skye's site is prett
/html/mgs/1999-02/msg00385.html (6,820 bytes)

27. Re: MGB Front Springs (score: 1)
Author: Carl Elliott <grunt2@adelphia.net>
Date: Mon, 08 Feb 1999 13:06:20 -0500
Jack the car up put it on stands put the jack under the lower arm unbolt the sway bar link from the arm,Unbolt the bottom of the king pin, Then lower the jack under the control arm slowly, Don't stan
/html/mgs/1999-02/msg00389.html (6,863 bytes)


This search system is powered by Namazu