- 1. regulator (score: 1)
- Author: "John Adamik" <j.adamik@comcast.net>
- Date: Mon, 5 Sep 2005 21:26:19 -0400
- Hi Listers, I am in need of a regulator for a '62 BT7. My question is do I buy it from the M source, is there better elsewhere, or does make any difference? The one in my car (from the previous owner
- /html/healeys/2005-09/msg00140.html (6,458 bytes)
- 2. overdrive solenoid (score: 1)
- Author: "John Adamik" <j.adamik@comcast.net>
- Date: Sun, 20 Mar 2005 21:48:55 -0500
- Hi Listers, I just tried to install a Moss overdrive solenoid and found that a rubber plunger boot just didn't work. The original didn't have a rubber boot, and the new one appeared to be a situation
- /html/healeys/2005-03/msg00450.html (7,319 bytes)
- 3. overdrive solenoid (score: 1)
- Author: "John Adamik" <j.adamik@comcast.net>
- Date: Sat, 26 Mar 2005 22:35:47 -0500
- I installed a new overdrive solenoid and went through the setup per the manual. I had read from an old overdrive article (club magazine, Norman Nock) that upon initial power up, the solenoid should d
- /html/healeys/2005-03/msg00595.html (7,183 bytes)
- 4. front suspension play (score: 1)
- Author: "John Adamik" <j.adamik@comcast.net>
- Date: Sun, 30 Jan 2005 11:06:01 -0500
- While poking and prodding the car while it is up on jack stands, I noticed that the front left wheel has about 1/32" of play when push/pulled (slight clunk), hand on the top and bottom of the tire. I
- /html/healeys/2005-01/msg00616.html (7,545 bytes)
- 5. starter problem found (score: 1)
- Author: "John Adamik" <j.adamik@comcast.net>
- Date: Mon, 20 Dec 2004 21:59:04 -0500
- Hi List, I probably should have taken the starter out before consulting the list; I appreciate all of the input from everyone. Upon removing the starter, I found that the heavy spring, shaft nut and
- /html/healeys/2004-12/msg00442.html (6,738 bytes)
- 6. starter troubleshooting (score: 1)
- Author: "John Adamik" <j.adamik@comcast.net>
- Date: Sun, 28 Nov 2004 16:17:33 -0500
- Hello Listers, isn't is strange how the healey knew that I was taking her for a "last of the season" ride when she decided not to start after gassing her up. It sounded like the starter pinion was sp
- /html/healeys/2004-11/msg00514.html (7,626 bytes)
- 7. sluggish tach (score: 1)
- Author: "John Adamik" <j.adamik@comcast.net>
- Date: Wed, 19 May 2004 21:40:05 -0400
- During this spring's "clean out the exhaust" run I discovered a very sluggish tachometer. It appears to indicate the proper rpm, but just takes a few seconds to get there (i.e. heavily damped). Any s
- /html/healeys/2004-05/msg00504.html (6,605 bytes)
- 8. front hub outer race removal (score: 1)
- Author: "John Adamik" <j.adamik@comcast.net>
- Date: Sun, 19 Mar 2006 15:30:02 -0500
- Hello listers, time to replace the front right hub since I'm tired of hearing the proverbial clunk upon the first braking in the morning. The spline teeth are as sharp as razors. I managed with a dri
- /html/healeys/2006-03/msg00497.html (6,801 bytes)
- 9. tonneau rail too long (score: 1)
- Author: "John Adamik" <j.adamik@comcast.net>
- Date: Sat, 25 Feb 2006 22:40:04 -0500
- hi listers, I bought a tonneau support rail that is to long by about 2". Is this just the wrong rail or do I have to cut it to fit properly. Or, is my BT7 set up just differently. John BT7
- /html/healeys/2006-02/msg00615.html (6,989 bytes)
This search system is powered by
Namazu