The hydraulic method worked great for me. instead of the input shaft, I had a metric nut-driver that was just the right size, filled the cavity with grease and tapped it out without breaking a sweat.
I did this on a Datsun 320 truck, it might work for the roadster. I put a floor jack under the oil pan and jacked it up until the suspension just started to unload . Undo the fasteners on one side, m
Criterion 1 fit 4 6-our 200# 6-footers comfortably, and criterion 2, no longer than 14' are pretty much in direct contradiction, but there may be one or 2 out there. The Scion XB is a delivery-van wi
Yes, you can polish it in place with plenty of elbow grease, soft cloth, and Autosol, Flitz or a similar polish. I found Autosol at the local supermarket. Comes in a toothpaste type tube.
This may apply to an older system, but it is from a 320 truck book revised in september 1968 It says part numbers as a rule are 10-digit First (2 digits), Section # indicate major function of parts (
If you can't actually feel the etching with your fingernail, it can be polished out. http://www.advanceautoparts.com/english/youcan/html/ccr/ ccr20030101wp.html
A couple years ago i had my radiator rodded out , but they put so much thick black paint on it that it's not performing particularly well. I'm considering replacing it with a del Sol Radiator or some
I wonder if a silicone adhesive like a Permatex would work. It seems like it would fill gaps sufficiently. The surfaces would have to be cleaned of all the nasty gooey burned rubber (both the metal p
Fear not, the Metro came with the BMC "B" series engine, not the "A". At 1500cc displacement, it's the same unit as in the MGA. The 1500 engine dropped into the midgets in '75 was the triumph Spitfir
Okay, so I know the front fenders bolt on, but how do you get to the bolts at the rear of the fender? do you have to remove the doors? -Marc == Marc Tyler Sisterdale TX 1970 1600 #SPL311-31016 1965
I had a college prof with an ancient Peugeot wagon. The thing looked like it had done the Paris-Dakkar rally a few times, but was dead reliable. Very cool car. Marc Tyler 70 1600 Peugeot bicycle made
Probably an E or J series head. These pretty much interchange with the BMC B series motor used in MGAs MGBs Metropolitan and others. Are the exhaust valves about the size of Nickels?
My washer pump went bad a few years ago. I pulled the motor from the tank and took it to Autozone, or some such place, and found a pump/motor unit that was close in size and it fit fairly well in th
CAUTION!! If you do this, DO NOT re-use the fastener. Quenching the dull red steel with water will work harden the metal making it brittle. It could fail under load. == Marc Tyler Sisterdale TX 1970