Agree, JB Weld will do the job.
Bill B
TS30800L
-----Original Message-----
From: Triumphs [mailto:triumphs-bounces@autox.team.net] On Behalf Of
auprichard@uprichard.net
Sent: Wednesday, December 1, 2021 10:24 AM
To: 'Dave Connitt' <dconnitt@fuse.net>; 'Triumphs' <triumphs@autox.team.net>
Subject: Re: [TR] TR4A trunk hinge question
I have had this happen a few times. I have not had success with Locktite, but
JB weld has worked.
Andrew Uprichard
Jackson, Michigan
-----Original Message-----
From: Triumphs <triumphs-bounces@autox.team.net> On Behalf Of Dave Connitt
Sent: Wednesday, December 1, 2021 10:48 AM
To: Triumphs <triumphs@autox.team.net>
Subject: [TR] TR4A trunk hinge question
Hi all,
Itâ??s been some time since I have posted on this list but here goes.
During the restoration of my TR4A, I had purchased a new set of hinges for the
trunk which was about 10 years ago.
After noticing one hinge coming apart I found that the short threaded stud one
that hinge actually pulled itself out of the hinge.
Two questions:
1. Is this a common failure mode?
2. If I used red Locktite or JB Weld to secure the studs would they stay put?
Thanks,
Dave Connitt
DavesTR4A.com
Sent from my iPhone
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/auprichard@uprichard.net
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/notakitcar@yahoo.com
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|