[TR] TR6 Zenith Stromberg Carbs

["Henningsen, James D." <henningj@cf.edu>]

Ok, itâ??s been a while since Iâ??ve adjusted the mixture on my ZS 175 CD-2 
carbs on my TR6.  I have the adjustable B1AF needles,  removed damper from carb 
body, removed the fixing screw from the piston damper side.  I insert the 
special tool into the damper tube to turn the needle assembly and it engages 
the hex socket hole.  I can rotate left and right but it doesnâ??t move the 
height of the needle face on the bottom of the damper no matter which way I 
turn.    If I pull the needle down from the damper to its lowest spring 
position and then turn left or right, the needle seat height does move up and 
down.   I donâ??t recall having to hold the needle out to adjust mixture.  I 
also canâ??t easily find the fully lean or rich stop points easily.  Ten turns 
seems a bit much.

Any thoughts greatly appreciated.  Trying to get my refreshed 6 back on the 
road from a major engine drivetrain upgrade. Thanks I advance 

Jim Henningsen
Ocala FL
** triumphs@autox.team.net **

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs  http://www.team.net/archive

Unsubscribe/Manage: 
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net