Yes, Moss carries an aluminum head, about $3,000. I donâ??t worry about any
sequence for loosening, for tightening use the sequence in the book, after
tightening to 50ftlbs tighten in steps of 20ftlbs through the sequence until
you get to the specified 105ftlbs.
Bill
Sent from my IBM 8088
On Sep 2, 2019, at 8:10 PM, Paul Dorsey <dorpaul1@gmail.com> wrote:
Gotcha! I may be dumb but I I am dumb, but,Iâ??m no dummy, I donâ??t have an
aluminum head on my motor. Do theymake aluminum heads for our motor or do they?
Anyway theyâ??re out of my price range.
As I was loosening the bolts that hold the head on, I got to thinking, I
wonder if there is a sequence for loosening these head nuts . Metal bends,
You know. Perhaps that is more critical for something like aluminum heads.
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/wbeech@flash.net
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|