Thanks Randall, Iâ??m sure you are correct as the pedigree here is a bit
suspect. Iâ??ll cap the ports off and head on to bigger things.
Bill B
Sent from my Handspring Treo
> On Dec 1, 2018, at 10:10 PM, Randall <TR3driver@ca.rr.com> wrote:
>
> Installing a pair of HS6 SU carburetors from a TR4 on a stock
> TR3A motor. With regards to the vacuum-in ports on the carbs
> that would normally connect to the PCV line from the rocker
> cover. Does it matter whether i plug the two ports or should
> I run a line between them? Or is it just sixes?
I believe that was only on TR6. TR4A and TR250 used a real PCV valve
plumbed to the intake manifold.
But if you had them, you could just cap them off.
-- Randall
56 TR3 TS13571L once and future daily driver
71 Stag LE1473 - awaiting engine rebuild
71-2-3 Stag - awaiting gearbox rebuild
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|