triumphs
[Top] [All Lists]

[Fot] Ignition Coil ??

Subject: [Fot] Ignition Coil ??
From: tjwakeman at gmail.com (TeriAnn J. Wakeman)
Date: Tue, 21 Aug 2018 05:17:10 -0700
References: <1655a2d220d-1e9c-20995@webjas-vab159.srv.aolmail.net>
On 8/20/18 6:50 PM, Bob Totten via Fot wrote:
> Amici,
>
> So this weekend I believe my 2 year old coil crapped out, last run at 
> Saturdays autocross there was sputtering and backfire.? At home barely 
> could get the car off the trailer and into the garage.
That is also the symptom of a bad condenser. If it were me, unless there 
is something visibly wrong with the coil, I would first check the point 
gap, underside of the cap, and swap out the condenser before going out 
and buying a new coil.

Currently an Epoxy Pertronix black coil, with Ballast Resistor, in a 
Spitfire with a 1500 engine 11 to 1 comp and a Mallory Dual Point 
Distributor.

I'm running a Mallory distributor as well, and it used to go through 
condensers on a regular basis. The ignition circuit assumes a good 
ground through the distributor body. My car's distributor body wasn't 
making a good enough ground. after a while I added a ground wire between 
the distributor body and the engine. Since then I have not needed to 
touch my onboard spare condensers.


TeriAnn


-- 

Book - The Essential Guide to Overland Travel in the United States and 
Canada <http://overlandtravel.us>
2 years to write and 38 years of travel and camping to learn what to write

*Because the world beckons and life waits for no one*

-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/fot/attachments/20180821/acf8979c/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>