triumphs
[Top] [All Lists]

[Fot] Inner axle shaft of IRS rear axle moving outwards.

Subject: [Fot] Inner axle shaft of IRS rear axle moving outwards.
From: van.mulders.marcel at telenet.be (van.mulders.marcel at telenet.be)
Date: Thu, 12 Jul 2018 23:25:38 +0200 (CEST)
The inner axle shaft (right side) has moved out of the axle house by as much as 
12mm, so far that a lot of oil has leaked after a race. 
The ball bearing has slided inwards on the axle shaft by the same amount 
(retained by the oil seal housing). Has anyone experienced this? Before? I 
noticed these bearings had moved a little, but never more than 3mm. In fact, 
nothing does prevent the bearing of sliding on the axle shaft, except the 
interference. 
Does someone know a fix? Loctiting the bearing on the axle shaft? Machining a 
groove for a circlip? 
Marcel. 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/fot/attachments/20180712/b6aa4e7b/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>