Good opinion on replacing the slave as well.? Been my experience over many
years if one goes the other is not far behind.? It becomes the weak link in the
chain.? It also goes without saying that for racing put in the braided line!!!
Rich
On ?Friday?, ?May? ?4?, ?2018? ?10?:?52?:?28? ?AM? ?EDT, Bill Tobin via Fot
<fot at autox.team.net> wrote:
Hi Brian, as an old friend told me, and from personal experience, you have
about a 50-50 chance of success when rebuilding these. For my 2 cents, I'd buy
two of the less expensive ones, put one on the car and the other for spare. Or
buy the more expensive one to put on the car and the cheaper one for spare.You
might want to replace the slave too while you're at it.Also from my experience,
trying to save a few bucks and go the cheaper route usually bites you in the
butt. Also on my TR6, there was kind of a plastic line going to the slave. It's
been replaced by a braided line yrear ago. Cheap insurance.Good luck.Bill-----
Original Message -----
From: Brian Schirano via Fot To: FOT Sent: Thursday, May 03, 2018 10:46 PM
Subject: [Fot] clutch master opinion
Hey Guys
I need to replace my clutch master cylinder then rebuild the old one as a
spare.? Quick opinion survey for GT6 clutch master cyl mfg
TRW PNB454 $91 at BP Northwest?
or?
Beck/Arnley 072-1308 ~ $51 Rock Auto or Amazon
Or?
Thanks Brian
26A GT6+, 28 TR6Brian Schirano
585-305-0349 Cell?
BSchirano at yahoo.com
_______________________________________________
fot at autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/pipermail/fot
_______________________________________________
fot at autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/pipermail/fot
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20180504/5094869a/attachment.html>
|