Argh,,,, guess I need to go survey the situation a bit more...
Thanks
Carl
-----Original Message-----
From: Randall [mailto:TR3driver@ca.rr.com]
Sent: Thursday, October 22, 2015 8:37 AM
To: cfmtr3a@verizon.net; 'list Triumph' <triumphs@autox.team.net>
Subject: RE: [TR] TR3A Grab Handle Screws
> Does anyone know the size/type of the screw used to mount the grab
> handle on
> TS81802 ? The Parts Manual appears to have only the pre-60k
> because there
> is no way to get a Simmonds fix nut (speed nut) behind it.
On the post-60K body I parted out, there were slots in the sheet metal on
the bottom of the rail which gave just enough room to slide the fix nuts
into place. (Had kind of a hard time getting them back out.) So I believe
the YJ2526 screw shown in the later SPC is correct for post-60K.
But that was a long time ago, so I could be wrong.
Randall
--
I am using the free version of SPAMfighter.
SPAMfighter has removed 636 of my spam emails to date.
Get the free SPAMfighter here: http://www.spamfighter.com/len
Do you have a slow PC? Try a Free scan
http://www.spamfighter.com/SLOW-PCfighter?cid=sigen
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|