moss says its same part as the TR3.
if that's so the side piece at 90 degrees
screws out
Frank
On Friday, October 25, 2013 11:24 AM, James Henningsen
<trguy75@gmail.com> wrote:
List:
I purchased the correct original heat
valve pipe outlet that comes out of
the head as what was there from the
previous owner was not original. This
heater valve screws into this fitting.
Problem is that you can't screw it
into the head as it hits against the rear
head mounting stud and nut. I
can't believe that you have to install this on
the head before mounting to
the engine, but any thoughts out there. The only
idea I came up with is to
use a short extension pipe and then screw the orig
fitting into that, but I
really want it to be correct. Moss part number
635-260 under heating
section.
Thanks in advance,
Jim Henningsen
Ocala , FL
62 TR4
75 TR6
** triumphs@autox.team.net **
Donate:
Archive: http://www.team.net/archive
Forums:
http://www.team.net/forums
http://autox.team.net/mailman/options/triumphs/yellowtr3@yahoo.com
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|