I am the guilty party who fabricated the homemade tool Randall has
referenced. I neglected to put any contact information in the write-up.
If anyone would like their hubs separated I am glad to do it for the
cost of shipping the axle/hubs back to the owner. I won't rebuild the
assembly but will do the separation. The tool works very well and I
can usually send the separated assembly back to the owner the day
after I receive the parts so this minimizes downtime.
The biggest problem I encounter is that many hubs are somewhat bent
when received so I now throw the assembly in a lathe to check hub
runout before separating and let the owner know the findings before
doing any work.
With this tool the hub is supported on the front and rear face so
there is no "spring" in the assembly when released therefore there
is no violent separation. It is hard to tell when the two pieces have
parted ways!!
The tool was interesting to design and time consuming to fabricate
but I suspect I am almost as stubborn as Randall (in that way).
Gene Wellenstein
Kewaunee, WI
At 10:27 AM 8/17/2013, Randall wrote:
> > Seeking advice on removal of rear hub. Made a tool from
> > splined wire wheel holder but still won't budge. Hate to try
> > Hub buster for fear of damage to axel. Hub is damaged now by
> > use of three pronged remover.
>
>This homemade tool looks like it would work well, if you can find the
>materials:
>http://tinyurl.com/mu6mcpj
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|