You're right, Darrell, I have a bag of them here. But unless there is a way
to mount those snaps half on the tonneau and half off I don't know if I can
get the thing mounted. But I get a lot of "you have to let it sit in the sun
and warm up" type of advice so I think I will do that.
BTW the TR3 grills (not the TR3A grills) being sold by Moss and TRF don't fit,
either, but for the opposite reason: too big.
Thanks and see you in 6 weeks.
Dave Massey
-----Original Message-----
From: Darrell Floyd <tr250driver@aol.com>
To: Dave Massey <dave1massey@cs.com>
Cc: triumphs <triumphs@autox.team.net>
Sent: Sun, Aug 18, 2013 6:23 pm
Subject: Re: [TR] TR3 Tonneau Cover
Dave,
Dum question but normally when purchasing a tonneau,boot cover or top etc. the
snaps are not installed so one can adjust the fit to one's car by installing
the
snaps where they required to be. I just did that procedure on a new TR8
boot
cover since my very nice original was eatin by a bunch of rouge mices.
Darrell
Sent from my iPad
On Aug 18, 2013, at 7:14 PM, Dave Massey <dave1massey@cs.com> wrote:ru
> Fore/aft. I haven't checked the port/starboard fit.
>
>
>
>
> Dave Massey
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|