Malcolm
i have just worked on this 2 weeks ago myself.
what i found with my
carbs was the existing bushings where only ever so slightly out of tolerance.
like 0.0015 to 0.002.
i found my shafts however where as much as 0.015 under
size at the bushing.
i simply replaced the shafts and have my idle down to
where it will stall if i wind the screws all the way out.
your results may
vary.
Frank
From: Malcolm <malcolm@ipatch.ca>
To: triumphs@autox.team.net
Sent: Tuesday, January 15, 2013 10:49 PM
Subject: [TR] Carb rebuild / reaming
Hi List,
Finally got the TR4 started, so it could do the 500 foot drive from
street
parking to get it inside the shop. Now the work begins!
Can anyone
recommend a place to have my carbs rebuilt and rebushed? I have
SU H6 AUC768
and they are missing a few original parts (like the AUC768
tag!) that I would
like to replace. The shafts are leaking and I'd rather
send them off than
fiddle with them myself.
Thanks!
-Malcolm
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/triumphs/yellowtr3@yahoo.com
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|