I have been unhappy with the fit of tonneau covers from both Moss & TRF.
None of them are cut large enough to reach all of the original studs, either
on my previous early TR3A or my current TR3.
I strongly suspect this is partly due to the studs moving around when the
Dzus-button side curtains were introduced. Only TRF even shows a break in
tonneau part numbers at that point (TS28xxx), but their "early" vinyl cover
didn't fit my car either. I had to completely skip the front corner studs,
and it was so tight over the remaining studs that the zipper has failed
after only 2 years of use (and only occasionally snapping the studs on the
driver's side).
Has anyone with a LHD TR3 bought a tonneau cover that actually fit?
-- Randall
|