When running the engine for the first time after installing my new Mad Marx
rear oil seal I noticed that a couple of the head bolts were weeping water
up through the threads. There were two of them on the manifold side on each
side of #2 cylinder. One built up a little puddle (about a teaspoon worth)
while the other just showed little bubbles. I've never seen this before.
During the install, while the engine was apart, I had removed the head
bolts for the first time in the engine's 44 year life. There was a lot of
crud built up on the bolts that I scraped off. The nuts are torqued down to
105 lbs.
Anybody seen this before? Will it stop?
Johnnie
'67 TR4A
triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|