HI Dave,
I am assuming that you are referring to the arm rests and the curve piece
that goes up the rear fender. The way I did mine was to create a wooden form
that was placed in a bench vise that the metal piece sat on while the
leather was carefully stretched on to it. The leather was soaked in water
over night in my tub. I used 3M spray adhesives and they came out great.
When the leather dries it is usually after the adhesives has, so it forms a
nice tight fit as it shrinks. The trick is the sharpest curve at the bottom.
This takes patience and a slow process of rolling it out with your fingers.
Any kind of mechanical roller like a wallpaper roller will only flatten out
the grain and it looks like crap. If you go to fast than you get wrinkles.
If you are interested in the form, I can try and dig a picture out. I
remember that I saw the form on this forum, so someone else has it also.
Alex Manzo
59 TR3A
----- Original Message -----
From: <Dave1massey@cs.com>
To: <triumphs@autox.team.net>
Sent: Tuesday, August 02, 2011 4:44 PM
Subject: [Bulk] Re: [TR] TR3A leather trim
> In a message dated 8/2/2011 1:57:10 PM Central Daylight Time,
> geomurphy@windstream.net writes:
>> I am restoring a 1960 TR3A. I have leather and vinyl strips from the
>> Roadster Factory that supposed to be sufficient to cover the Dash and all
>> the trim pieces. I have enough leather to cover the long piece above the
>> dash and two doors and the two arched pieces directly behind the doors.
>> But
>> There are three other trim pieces that are under the convertible top when
>> in
>> the down position. One long piece in the very back and two that are in
>> the
>> rounded corners. Should these three pieces be covered in leather or the
>> vinyl material? Thanks George Murphy, 60 tr3A Waleska Ga.
>>
>
> I received the same thing in my kit from Moss. I presume the rear capping
> pieces are to be covered with vinyl. Likewise, the leather seats have
> leather seating surfaces but the rest is vinyl. >et me know if you
> figured out
> how to stretch the leather over those curved pieces. I gave up and I'm
> going
> to sent them off to someone further along the learning curve.
>
> Dave
triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|