i think the studs are a 2 part product.
the threaded part seems to run from the very top all the way to the end of the
threads.
the hex drive and body appear to be a separate part that is spin riveted around
the threaded part.
hammering on one part may cause them to separate into 2 pieces. without
hammering i have one on my car that has separated and will not come out. ill
need to cut it out with the dremmel
Frank
________________________________
From: carlsereda <carlsereda@aol.com>
To: triumphs@autox.team.net
Sent: Wed, May 11, 2011 2:05:50 PM
Subject: Re: [TR] peening lift the dot studs
guessing a little here on your intentions...
a pointed 'nail punch' if you want to slightly expand the portion (from behind)
that goes into the screw down bracket - or a small socket, say 8mm or 3/16" if
you want to hit the edges around the portion of stud protruding from underside
of the screw-down bracket. In either case gonna need to be careful to hold the
peg securely (on the sides and at the pointed end) so as not to damage them..
(maybe drill a shallow hole in hardwood to insert the peg so you can bang away
on other end without damaging pointy end)
Carl
'63TR4 since '74
Can anyone recommend a tool, that is not a ball-peen hammer, for peening the
ends of lift-a-dot studs?
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|