On 11/24/10, cfmtr3a@verizon.net <cfmtr3a@verizon.net> wrote:
> ...the wiring was "tied" beneath the bumper
> supports - routed behind the bumper & overrider to the lamps. Very sloppy
> look...
Like the wires for the license plate lamps on the TR4?
Will probably look neater if run thru a plastic sheath. On the TR4
rear they attached the license plate lamp wires to the black steel
bumper brackets using metal clips -- a route and method that might be
a bit more discreet for the driving lamps.
I suppose those holes in the supports were for drainage. Even if
enlarged I would be concerned about wire chafing if run thru them.
Geo
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|