I wasn't going to mount them until much later - however - as I was looking at
the bumper/over-riders I noticed that the overrider support tubes have holes in
them (front & rear on the bottom). Although it would be very difficult to feed
wiring through them as they are - if larger it would be possible.
In its earlier incarnation - the wiring was "tied" beneath the bumper supports
- routed behind the bumper & overrider to the lamps. Very sloppy look. The
above would be a more direct route and be hidden from view except the last 3-4".
Anyone else tried it? Any thoughts?
Carl
It is definitely looking like a car again....
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|