Date: Wed, 8 Sep 2010 15:45:21 -0400
From: "Jeff" <fishplate@charter.net>
Subject: Re: [TR] TR4 Fuel Line fittings at Fuel Pump
> Also, I want to build into my fuel delivery system an auxiliary,
> low-pressure facet pump. Would such an 'in-line' pump be able to pump
> through the mechanical pump, or do I need to bypass it, should the
> mechanical pump fail (again)?
My Spitfire is done this way...most of the time the Facet is turned off and
the mechanical pump does the work. The Facet is mounted in the engine
compartment just ahead of the mechanical pump.
Jeff Scarbrough
Corrosion Acres, Ga.
------------------------------
Hi Jeff & Brian!
Yes! It can be done because I've done it to my TR4A.
Iinstalled all new lines, rubber flex hoses, PI clamps, Heat sheild 3 shut off
valves with a 'T' fitting. one line runs the org. way, at the Bulkhead, I put
the 'T' in & ran the other line up & around the engine & air filters to the
carbs & a toggel switch.
The gas runs thru the E-pump & the org line thru the M-pump to the carbs
WITHOUT the E-pump running. Then IF I do have problems, I can flip the switch
to keep me going so I can pull off to turn off the running to the M-pump &
open the bulkhead line & have the toggle switch on to finish off the ride to
work on the problem later that night or when I can get a chance.
-Cosmo Kramer
_______________________________________________
Triumphs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|