----- "tom white" <tswhitez123@hotmail.com> wrote:
> Another method to avoid splitting the venier when drilling is to tape
> over the
> area before drilling.
>
> Best regards,
> Tom
I'd suggest doing both. Buy a fresh roll of good masking tape. Then clamp the
dash to a piece of hardwood. Use a sharp drill. You only get one chance to do
this right, so going over the top on prep may be worth it.
Phil Ethier West Side Saint Paul Minnesota USA
1962 Triumph TR4 CT2846L
1979 Caterham 7
1994 Miata C-package
2004 Suburban 8.1
2007 Saturn Ion 3 2.4
http://www.triumphtransamerica.org.uk
http://forum.mnautox.com/forums
http://www.flickr.com/photos/pethier
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|