first, i will admit to being prejudiced - jim at litezupp is a good friend
of mine.
imho you did not use the litezupp lites. and if you want, i will ask jim to
send you one to test and compare if you will promise to publish the results
on this forum.
they do not have just a few bright spots. look at Brian's blog.
http://brianjones.tumblr.com:80/
on an mgb, the lenses are fairly large and you can turn around in the car
and see the top of them. in my mgb, they shine birghtly and are quite
visible from inside the car. on the TR6 they is also a very noticable
difference.
----- Original Message -----
From: "scotts junk" <smacsjunk@hotmail.com>
To: <mtgaines@mail.presby.edu>; <triumphs@autox.team.net>
Sent: Friday, December 04, 2009 2:17 PM
Subject: Re: [TR] LiteZupp LED lights
> Not the particular brand mentioned, but our club did an informal test on a
> few
> 1156 and 1157 LED lights. Findings were:
>
>
>
> 1) There is a lot of variation in brightness among the various brands. The
> bulbs we tested ranged from less light than the regular filament bulb to
> significantly brighter at certain places (see 2 below)
>
>
>
> 2) Regular filament bulbs throw off light around almost 360 degrees (at
> least
> in the roughly horizontal plane where they are normally viewed). A lot of
> this
> light hits the reflector in the taillight assembly, is diffused and
> reflected
> back out through the lens. This gives a relatively even brightness when
> viewed
> from anywhere behind the car, even at right angles to the cars long axis
> (this
> of course varies with the lens type and rear ligt layout, but is generally
> true). The LEDs we tried (and from appearances, the ones on the website
> referenced) directed all their light away from the reflector, so there was
> no
> diffused, reflected light going through the lens. This leaves only a few
> very
> small, very intense light sources. The result was, as you walked around
> behind
> the car there were some very bright spots and some very dim places. The
> light
> was especially dim away from directly behind the vehicle, with almost no
> light
> visible when looking from the side of the vehicle. The lenses on our cars
> were
> designed for a diffuse light source, not point sources, so the light
> distrubution is quite poor. I have seen an LED bulb built with rings of
> LEDs
> aimed to the side and base of the bulb but we haven't tested them.
>
>
>
> 3) Some vehicle's flasher units use the resistance in the filament to time
> the
> flasher - these will require a replacement non-restance flasher unit if
> going
> to LEDs.
>
>
>
> Based on our trial (we were looking at a mass buy) we decided that LEDs
> weren't yet developed to the point where they were an improvement on the
> old
> hot filament bulbs and didn't install them.
>
>
>
> cheers
>
> Scott
>
>
>
>> Date: Fri, 4 Dec 2009 09:55:54 +0000
>> Subject: [TR] LiteZupp LED lights
>>... LiteZupp (url below) has LED
>> units that are direct plug-in replacements for the usual 1156 and
>> 1157 light bulbs. They claim the units are much brighter and, of
>> course, take much less current. I'm tempted, but the $25 price per
>> unit isn't trivial. Has anyone tried these out?
>
>> http://www.litezupp.com/Litezupp.Com/Welcome.html
>>
>
>
> _________________________________________________________________
> Windows Live: Friends get your Flickr, Yelp, and Digg updates when they
> e-mail
> you.
> http://go.microsoft.com/?linkid=9691817
>
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|