On 11/18/2009 10:06 PM, Tom Boggiano wrote:
> I am at the point of my engine re-rebuild that I need to prime the oil
> pump and have a couple of questions
> What do you all use to turn the oil pump with, A drill and what in the
> shaft? A long handled screw driver?
> On the TR4 engine does it turn anti - clockwise?
Tom, I just used the distributor drive shaft. Put #1 at TDC, pull the
dist and distributor drive gear and turn the shaft CCW using a 1/2"
drill; it'll take a minute to build up pressure. When reinstalling the
drive gear, orient the woodruff key directly opposite the block (if the
block is "12 o'clock", the key should be at 6 o'clock) and the drive
gear should just drop right into place, pointing to the #1 exhaust
pushrod tube. Very simple, very easy. As a lark I created a YouTube
video. If you want it, I'll look up the number.
jim
>
> If anyone has a gadget they used could you send me a picture?
>
> Thanks
> Tom
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
>
> http://www.team.net/archive
>
>
--
Jim Hassall
Blacksburg VA
'63 TR4 in autox preparation
99% finished, 90% to go
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|