I make sure to put the RTV on very thinly - I use a finger and smear
it on the gasket surface in a very thin layer to minimize the
"strings of gasket". Good point. Hylomar is fine too - it's really
intended for two surfaces without a gasket in between. We used to
use it at the back of a Hewland Gearbox - just aluminum to aluminum
and a thin coat of hylomar. It also doesn't set up (at least not for
a LOONNNGG time).
- Tony
At 07:59 PM 10/27/2009, Michael Lang wrote:
>I would recommend the Hylomar since it has worked well on my pan gasket.
>I would absolutely not use Permatex Aviation. I once spent a very long
>evening on my back under a Chev 216 scraping dried Permatex Aviation off
>of the bottom of the block. I wouldn't wish to do that again.
>
>I have heard so many stories about loose strings of silicone gasket
>maker plugging things up that I tend to stay away from those products.
>
>Mike
>
>Jeremy Kinney wrote:
> > I am getting ready to install a new oil pan gasket. What would you guys
> > prefer to add to the gasket? Wellseal, Hylomar, or Permatex Aviation
> > Form-A-Gasket No. 3 Sealant?
> >
> >
> >
> > TIA,
> >
> > Jeremy
> >
> > '66 TR4A
>_______________________________________________
>
>Support Team.Net http://www.team.net/donate.html
>
>This list supported in part by the Vintage Triumph Register
>http://www.vtr.org
>
>
>Triumphs@autox.team.net
>http://autox.team.net/mailman/listinfo/triumphs
>
>
>http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|