Andrew:
I did a bit of a dry run with the glazing (this is rubber and not the
original cloth like material that was used by the factory) and found it very
hard to avoid all binding on the corners. It would require lots of cuts and
removal of rubber. Would you think it could be okay to only place the
glazing on the straight sections of the windscreen (sides, top and bottom)
and not do the corners? Other Lister's experience in doing this? Thanks.
Scott Suhring
Mechanicsburg, PA
'70 TR6
'59 TR3
-----Original Message-----
From: Andrew Uprichard [mailto:auprichard@comcast.net]
Sent: Wednesday, September 30, 2009 7:33 AM
To: 'Scott Suhring'; 'Triumph Mail List'
Subject: RE: [TR] TR3 Windscreen glazing
I used epoxy to glue the glazing to the glass (trim at the corners) and then
a lot of soap and water to get it into the frame.
Andrew
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Scott Suhring
Sent: Wednesday, September 30, 2009 6:46 AM
To: Triumph Mail List
Subject: [TR] TR3 Windscreen glazing
I am curious if there is any advice on best to install the rubber glazing
around the windscreen and fitting this into the frame. Seems like a tight
fit. TIA
Scott Suhring
Mechanicsburg, PA
'70 TR6
'59 TR3
_______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|