That does not sound normal. I wonder if you got the right size
bearings... What you describe is what happens if the bearings are tight.
- Tony Drews
At 10:02 PM 8/30/2009, Art Graves wrote:
>I have a 1976 TR6 whose last engine rebuild was 180K miles ago in 1988.
>Yes, I drive my car a lot. Lately it seemed to have less power than it
>should so I did a wet/dry compression check that pointed to worn rings. Wet
>compression was 10 - 20 lbs higher.
>
>So I replaced the rings and rod bearings. Before I did this work I could
>easily turn the crank (with plugs out) by pushing the car in 4th gear. Now
>it is much more difficult, even with the head off. In fact, by the time new
>rings were on the third piston, turning the crank was more difficult. The
>starter will turn the crank, but it is definitely working hard.
>
>I suspect this is normal and once the engine has run for a bit and the rings
>have set, all will be okay. My question is, has anyone else experienced
>this? Does this sound normal?
>
>Thanks,
>
>Art Graves
>Tulsa, OK
>1976 Triumph TR6
>1985 Jaguar XJ6
>_______________________________________________
>
>Support Team.Net http://www.team.net/donate.html
>
>This list supported in part by the Vintage Triumph Register
>http://www.vtr.org
>
>
>Triumphs@autox.team.net
>http://autox.team.net/mailman/listinfo/triumphs
>
>
>http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|