interesting - I have two - with almost exactly the same dimensions as yours.
So, as someone else stated, it appears that the opening as been 'squashed'
about 3/4".
Now, I just need to figure out how to force the mouth open a bit without
creating havoc. Tom - I'll take you up on your offer to call tomorrow
morning.
Thanks to all...
Carl
----- Original Message -----
From: "THOMAS FANSHER" <tfansher@comcast.net>
To: "Carl TR" <cfmtr3a@verizon.net>; "Triumph List"
<triumphs@autox.team.net>
Sent: Thursday, August 20, 2009 2:41 PM
Subject: Re: [TR] TR3A Grill Opening
>I measured my two and this is what I came up with. Roughly 42" across the
>widest part of the mouth on the body and 8" tall.
> One grill measures 42.5" wide (with the lip) and one measures 42.25". the
> 42.5" grill is 8.5" tall and the other is 8.25" tall including the lip.
> The "shorter" grill is installed and some bowing may make for the shorter
> measurements.
> Hope this helps.
> Tom
> ----- Original Message -----
> From: "Carl TR" <cfmtr3a@verizon.net>
> To: "Triumph List" <triumphs@autox.team.net>
> Sent: Thursday, August 20, 2009 11:38 AM
> Subject: [TR] TR3A Grill Opening
>
>
>> Is there anyone that could measure the TR3A grille opening or a
>> well-fitting
>> Grille
>> I guess at the point where the screw holes are on the 'mouth'.
>>
>> Widest point across the top
>> Tallest point at the middle
>>
>> I am trying to figure out what is out of whack on mine.
>>
>> Thanks
>> C
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|