I recall from 40 years ago that there were special pins sold that were "T"
shaped. You would insert the pin into the oil hole in the crank and then
rotate the crank toward the locating tab on the bearing insert. The pin would
push the bearing out.
Best regards,
Tom
_________________________________________________________________
Hotmail. has ever-growing storage! Dont worry about storage limits.
http://windowslive.com/Tutorial/Hotmail/Storage?ocid=TXT_TAGLM_WL_HM_Tutorial
_Storage_062009
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|