It can be done in a TR-2/3/4, not sure about the 6 cylinder,
though. Measure the crank well so you are reasonably certain the
clearances will be OK.
- Tony Drews
At 02:55 PM 7/8/2009, Ed Woods wrote:
>List,
>
>Any chance the TR250 engine's main bearings can be replaced without removing
>the crank? That is, slipped into place like the thrust washers?
>
>Thanks,
>
>Ed Woods
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|