Eric;
I have attached an article that I scanned from a very old TRA newsletter
which was written by Joe Richards. Because it was scanned, the pattern will
not be to scale but if you know how to change the size of PDFs you can get
it exact. All dimensions are there so you can cut the piece even with no
pattern.
BTW, there were three different designs used on TR3s; plans for all are
included in the article. The list will not get the attachment so if anyone
else is interested, give a shout or find issue #64 of TRA newsletter.
Joe
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Eric Bartleson
Sent: Saturday, May 23, 2009 12:14 PM
To: triumphs@autox.team.net
Subject: [TR] TR3A Rear Seat Plans
Does anyone have drawings to cut out a replacement seat platform for a
TR3A?
I have seen them on one of the lists I visit.
Eric
[demime 1.01d removed an attachment of type application/pdf which had a name of
Rear Seat Build.pdf]
[demime found a multipart/alternative section which it tried
to parse but could not find any section which it could render. Please send
plain text.]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|