In case you don't know... I think there were at least 2 styles, an earlier
with a more rounded front edge and corners and a later straighter
squared-off design. Perhaps this change coincided with the change in the
sheet metal pressing for the rear area.
Geo
On Sat, May 23, 2009 at 9:14 AM, Eric Bartleson <ebartle@hbci.com> wrote:
> Does anyone have drawings to cut out a replacement seat platform for a
> TR3A?
>
> I have seen them on one of the lists I visit.
>
> Eric
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|