I haven't looked yet but try McMasters-Carr http://www.mcmaster.com/
Bill B
'58 TR-3A TS/30766 L
'59 TR-3A TS/64974 LO
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of bob@texmog.com
Sent: Wednesday, March 04, 2009 12:44 PM
To: Triumphs@autox.team.net
Subject: [TR] Nuts for the Head Studs TR-3
I'm missing some of the nuts for the head studs on the engine I am building
( with the much appreciated help of many on this list). I have some Grade 8
nuts that I was planning on using but after reading Uncle Jacks Engine
Rebuilding Tips I see where he recommends the use of 'Hardened and Ground'
washers. Which got me to wondering if Grade 8 nuts also not be appropriate.
So the question do I use Grade 8 nuts with the old washers, new grade 8
washers and nuts or find someone who can supply hardened nuts and washers?
Also if I have to get new nuts any recommendations? NWBP does not carry
them.
Thanks in advance for any help
Bob Nogueira
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as wbeech@flash.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|