Bill,
I was able to re-use the bracket and throttle linkeages from my TR6 when
converting it to HS6's.
Joe Curto may be able to provide what you need. http://www.joecurto.com/
Here are some pictures of the conversion:
http://www.geigergarage.com/images/TR6_SU/page01/index.htm
Terry Geiger
www.GeigerGarage.com
----- Original Message -----
From: "William Brewer" <wsb1960tr3a@att.net>
To: "Triumphs" <triumphs@autox.team.net>
Sent: Wednesday, January 21, 2009 1:09 PM
Subject: [TR] Fw: Need SU HS6 Part Measurement or the part itself
> The HS6 part in the inquiry below is NLA from MOSS or anyone else that
> I
> can find. If I could buy one used, I might make tooling to replicate it so
> other people could get HS6's on a TR3 or 6.
>
> Bill in Tehachapi
>
> From: William Brewer <wsb1960tr3a@att.net>
> Subject: Need SU HS6 Part Measurement or the part itself
> To: triumphs@autox.team.net
> Date: Tuesday, January 20, 2009, 8:57 PM
>
> I've picked up a pair of HS6's and am toying with fitting them on
> my TR3A. I am missing the "U" shaped sheet metal bracket that bolts
> between the carbs and holds the bell crank and spring (MOSS part #
> 371-900).
> I
> was wondering if any listers have an extra laying around that they would
> part
> with. If not, does someone currently have their HS6 (for TR4) carb bracket
> off
> of their car and could they trace an outline and give me the offset
> measurements
> (side view) so I could fabricate my own?
> Contact me off list please.
> TIA,
>
> Bill Brewer
> Tehachapi, CA
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|