"Low speed, plenty of feed" was the mantra we were taught back in the day.
--
Ian
62 TR4
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Dave1massey@cs.com
Sent: Friday, December 19, 2008 8:30 AM
To: triumphs@autox.team.net
Subject: Re: [TR] drill bits
In a message dated 12/18/2008 9:31:40 PM Central Standard Time,
mdporter@dfn.com writes:
> The most common mistake made with TiN-coated bits is
> not using enough pressure. Allowing such a bit to spin work-hardens to
> material to be cut and rubs off the coating, and the bit stops cutting.
Good point. Let me just add that the second most common mistake is too much
speed. Speed makes for friction, friction makes heat and heat will
de-temper
the drill bit and it will quickly become dull.
Use a drill press whenever you can. A drill press turns more slowly than a
hand drill and the mechanical advantage afforded by the crank wheel means
more
pressure will less exertion. That and a little lubricant can make you drill
bits last much longer.
Cheers
Dave Massey
St. Louis
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as lbc.resto@verizon.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|