> If so, is
> there a piece attached to the linkage to give the spring some
> leverage? Where on the linkage does the spring act? Is it on
> the rear carb shaft, or the centre section?
Mine is not a whole lot clearer, but I can see an additional lever attached
to roughly the center of the center section of throttle shaft, pointing
nearly straight up. Looks to be approx 1.25" or maybe 1.5" long. The
clamp-on crank from the front shaft would work well here, I think, but I
don't see any evidence of the clamp arrangement in Bob's photo. Looks more
like it was drilled to fit over the shaft, then soldered into place.
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|