> In the procedure described in the "MGA With An Attitude"
> website for calibration of a Jeager fuel gauge, the use of
> two 68 ohm resistors is called for: can anyone tell me where
> I can purchase resistors like this?
Radio Shack should still have them, or Fry's if there is one in your area.
Or any number of on-line suppliers, like Digi-Key
http://www.digikey.com/
or Mouser
http://www.mouser.com
or MarVac
http://www.marvac.com/
Or you could even check your phone book for a real electronic parts store in
your area; there are several near me (Signal Electronics, Torrance
Electronics).
However, you might want to double-check your sender resistance first. ISTR
the TR3 uses a slightly different resistance than the MGA does; like maybe
80 or 90 ohms instead of 70.
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|